Table of Contents
Advertisement
Reconnect the power cord to the power supply.
4.
Verify that the amber Fault-Service Required LED on the replaced power supply and the
5.
Fault-Service Required LEDs are not lit on the front and back panels.
If you disconnected the two CMA left-side connectors, reconnect the connectors or
6.
straps.
See
Oracle Database Appliance X10-HA Storage Shelf Hot
Pluggable Components
Perform hot plug tasks on an Oracle Database Appliance storage shelf.
Under most circumstances, Oracle Database Appliance X10-HA storage shelf components
can all be replaced while the storage shelf is powered-on and running. Any exceptions will be
described in the following procedures.
•
Adding Optional Storage Shelf Drives (CRU)
Add disk storage in an Oracle Database Appliance X10-HA storage shelf.
•
Replace a Storage Shelf HDD or SSD (CRU)
Replace a storage disk in an Oracle Database Appliance storage shelf.
•
Replace a Storage Shelf Power Supply (CRU)
Replace a power supply in an Oracle Database Appliance storage shelf.
•
Replace a Storage Shelf I/O Module (CRU)
Replace an IO module in an Oracle Database Appliance storage shelf.
Oracle Database Appliance X10-HA Storage Shelf Hot Pluggable Components
Note:
After you replace Power Supply 0, you must reset the Oracle ILOM service
processor (SP) to propagate the key identity properties (KIP) data to the new
power supply. For instructions on resetting the SP, refer to the Oracle Integrated
Lights Out Manager (ILOM) Configuration and Maintenance Guide at
ILOM
Documentation. Power Supply 1 does not contain KIP data, and therefore
does not require an SP reset after replacement.
Install the Cable Management Arm
(Optional).
Chapter 3
Oracle
3-11
Advertisement
Table of Contents
