Table of Contents
Advertisement
•
NVMe drive
5. Determine the status of the drive from the drive LED definitions.
6. If removed, install the bezel.
The installation is complete.
To configure arrays, see the HPE Smart Array SR Gen10 Configuration Guide at the Hewlett Packard Enterprise
website.
Drive cage options
Installing the 2SFF SAS/SATA drive cage
Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
Procedure
1.
If installed, remove the bezel.
2.
Power down the server.
3.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4.
Disconnect all peripheral cables from the server.
5.
Do one of the following:
58
Hardware options installation
Advertisement
Table of Contents
