Table of Contents
Advertisement
11. Connect the power and data cables.
12. Install the access panel.
13. Slide the server into the rack.
14. Connect each power cord to the server.
15. Connect each power cord to the power source.
16. Power up the server.
The installation is complete.
Installing a midplane 4LFF SAS/SATA drive cage
Observe the following:
•
A 1U heatsink is required for each processor when installing this option.
•
If you have a TPM, install it prior to this option.
•
If you have a type-a controller, install it prior to this option.
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
The components included with the hardware option kit
Procedure
1.
Power down the server.
2.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
102
Hardware options installation
Advertisement
Table of Contents
