Accept End-User License Agreement (Eula) - Agilent Technologies N9039A Service Manual

Accept End-User License Agreement (EULA)

When the A5 Disk Drive assembly is replaced a new operating system license is
issued for the instrument. This will require that the End-User License Agreement
be accepted.
The license agreement must be accepted for the operating system installation and
configuration to complete. If you do not accept this agreement the required
instrument adjustments and performance verification testing cannot be run and the
instrument will shut down. The setup wizard will again run from the beginning the
next time the instrument is turned on.
The following procedure will guide you through the process of accepting the
End-User License Agreement when an A5 Disk Drive is replaced:
This procedure outlines how to accept the End-User License Agreement, as well as
NOTE
other screens that need to be accepted when the instrument is first turn on,
assuming that you do not have a USB mouse or keyboard connected to the
instrument. If you do have a USB mouse and keyboard connected to the instrument
you can use them to perform the same task much easier.
1. With the A5 Disk Drive replacement completed plug the instrument power cord
2. Turn the instrument on.
3. After a few seconds the Agilent Welcome screen as shown in
Once the operating system Setup Wizard has been started it cannot be interrupted.
NOTE
If it is interrupted the operating system may become corrupt, requiring that the
Agilent Recovery System process be run, which would then require that this
process be run again from the start.
Chapter 8
into an appropriate AC power source.
displayed.
If you would like to turn off the instrument and proceed at a later time you will
want to do so at this point, before proceeding with the Step 4.
Post-Repair Procedures
What You Will Find in This Chapter
Figure 8-8 will be
225