Table of Contents
Advertisement
Assembly Replacement Procedures
RF Area
Switch SW1 or SW2
Removal
1. Refer to
2. Remove the semi-rigid cables W3, W4, W5, W6, W7 and W8 using the 5/16
inch wrench.
3. To remove either the SW1 or SW2 switch, remove the two associated screws
(2) using the T-10 driver. The switch can now be removed from the chassis.
Figure 7-8
Switch Removal
4. Refer to
(2) using the T-10 driver.
172
Figure
7-8. Separate the ribbon cable W2 from the switch wires.
Figure
7-9. To remove the switch bracket (1), remove the five screws
Chapter 7
Advertisement
Table of Contents
Troubleshooting
