Calibration File Backup - Agilent Technologies N9039A Service Manual

Post-Repair Procedures
What You Will Find in This Chapter

Calibration File Backup

Since all calibration and user data files are stored on the A5 Disk Drive assembly
they will be lost when the drive is replaced. If possible, backing up these files
before replacing the A5 Disk Drive, so that they can be restored afterwards, is
highly recommended. Of course, if the drive is completely nonfunctional this
cannot be done.
Backing up the calibration file will typically eliminate the need to run all of the
instrument adjustments once the drive is replaced. To do this you will need to
connect a USB mouse to the instrument and do the following:
1. From the Start menu select "My Computer"
2. Select the E: Drive (Calibration E:) by double-clicking on it
3. Enter the AlignDataStorage folder by double-clicking on it
4. Save a copy of the N9039ACurrentDataSet.mdb file onto a USB storage
device
Once a new A5 Disk Drive assembly is installed, copy the
N9039ACurrentDataSet.mdb file from the USB storage device to the
AlignDataStorage folder on the E: drive of the new A5 Disk Drive assembly.
If for some reason this file cannot be backed up, all of the instrument adjustments
will need to be run once the A5 Disk Drive assembly has been replaced. Refer to
Chapter 10 , "Performance Verification and Adjustment Software".
218 Chapter 8