Table of Contents
Advertisement
Assembly Replacement Procedures
Rear Panel
Rear Panel
Removal
1. Remove the instrument outer case. Refer to the
2. Refer to
3. Using the T-10 driver, remove the screws (3) attaching the rear panel (1) to
There is also a washer on each of the rear panel connectors on the inside of the
NOTE
instrument. When the rear panel is removed be sure that these are not lost.
Figure 7-10
Rear Panel Removal
174
procedure.
Figure
7-10. Remove the two nuts and washers (2) from the Digital
I/O board connectors.
the chassis and to the power supply. The rear panel can now be removed.
Instrument Outer Case
removal
Chapter 7
Advertisement
Table of Contents
Troubleshooting
