Table of Contents
Advertisement
Figure 8-13
Anti-Virus Message
If you do not check the box titled "Do not show this message again" in the
NOTE
Anti-Virus Message window before continuing this same message will be
displayed each time the instrument is powered on. While this message is displayed
the RF Preselector application will not start. This will cause the instrument to not
respond to the test software after turning it on without further user attention since it
will only respond when the RF Preselector application is running.
Chapter 8
that the instrument is not shipped with virus protection software as shown in
Figure 8-13
will be displayed. You will want be sure to check the box titled
"Do not show this message again" by pressing the
Post-Repair Procedures
What You Will Find in This Chapter
key and then
Select
.
Enter
229
Advertisement
Table of Contents
Troubleshooting
