Table of Contents
Advertisement
8. Attach the Programmed Disk Drive to the Top Shield using 4 pre-coated,
self-locking machine screws (0515-1227) as shown in
screws to 9 inch-pounds.
Figure 7-17
Top Shield/Disk Drive Assembly
9. Connect the Disk Drive ribbon cable from the Top Shield/Disk Drive/Ribbon
Cable assembly to the processor assembly. When the ribbon cable is fully
seated the two locking tabs will grip the sides of the ribbon cable connector.
10. Install the Top Shield/Disk Drive/Ribbon Cable assembly to the processor
assembly using 15 new pre-coated, self-locking machine screws (0515-1227).
Torque screws to 9 inch-pounds.
11. Replace the processor assembly. Refer to the
procedure.
Chapter 7
Assembly Replacement Procedures
Figure
7-17. Torque
Processor Assembly
replacement
Disk Drive
185
Advertisement
Table of Contents
Troubleshooting
