Table of Contents
Advertisement
Assembly Replacement Procedures
Disk Drive
4. Refer to
removing and discarding the 4 pre-coated machine screws (1) from the
processor assembly. Screws need to be discarded because dried coating can
cause cross threading.
Figure 7-16
Processor/Disk Drive Parts
5. Remove the ribbon cable from the Disk Drive and set the ribbon cable aside.
Discard the defective Disk Drive.
6. Locate the Programmed Disk Drive.
7. Connect the Disk Drive ribbon cable to the Programmed Disk Drive.
184
Figure
7-16. Uninstall the existing Disk Drive from the Top Shield by
Chapter 7
Advertisement
Table of Contents
Troubleshooting
