Front Frame Assembly
Removal
Make sure any connectors on the front panel are removed.
NOTE
1. Remove the instrument outer case. Refer to the
2. Refer to
3. Refer to
Figure 7-28
Front Frame Assembly Removal
Chapter 7
procedure.
Figure
7-28. Using the T-10 driver, remove the eight screws (1), four
on each side, to detach the Front Frame Assembly from the chassis.
Figure
7-29. Pull the Front Frame Assembly carefully away from the
chassis. Remove the ribbon cable W1 from the mother board.
Assembly Replacement Procedures
Front Frame Assembly
Instrument Outer Case
removal
205