Quantum LTO 2 User Manual page 488

Status Name
SAS_INTERFACE_CTIO_INITRESP_
TIMEOUT
SAS_INTERFACE_CTIO_
DATAPHASEERR
SRV_FAN_HIGH_TEMP_
DETECTED
SCSI_UNKNOWN_MODE_PAGE_
SUBPAGE
SRV_THREAD_UNEXPECTED_
INTERNAL_MESSAGE
SRV_THREAD_UNABLE_TO_PICK_
PIN
SRV_THREAD_UNABLE_TO_
UNPICK_PIN
SRV_THREAD_UNPICK_STILL_
HAS_PIN_AT_CHECK
SRV_THREAD_PULL_NO_STALL
SRV_THREAD_PULL_
UNEXPECTED_STALL
SRV_UNTHREAD_PULL_NO_
STALL
SRV_UNTHREAD_PULL_
UNEXPECTED_STALL
SRV_REEL_HW_DID_NOT_DETECT
_STOP
LTO-2 SCSI Interface Guide
Sense
Key Category
9BDh General
9BEh General
9BFh Servo
9C0h SCSI
9C1h Servo
9C2h Servo
9C3h Servo
9C4h Servo
9C5h Servo
9C6h Servo
9C7h Servo
9C8h Servo
9C9h Servo
Appendix A Message Codes
Description
Initiator Response Timeout returned
by lowlevel.
Data phase error detected by
lowlevel.
High temperature detected by ADC.
Unknown Mode page Subpage
An unexpected internal message is
received by the load thread task.
Unable to pick the pin after enough
retries.
Unable to unpick the pin after enough
retries.
Pin is still inside the grabber after
unpick.
Pulling tape to drive reel didn't stall.
Pulling tape to drive reel stalled
before the pin could reach the hub.
Pulling tape to the cart reel didn't
stall.
Pulling tape to cart reel stalled before
the pin could reach the grabber
mover.
This is an exception when HW does
not detect stop condition.
464