Completion Status; Table 212 Set Capacity Command Completion Status - Quantum LTO 2 User Manual

Completion Status

Table 212 SET CAPACITY
Command Completion Status
LTO-2 SCSI Interface Guide
Table 212 shows the completion codes and messages for the
2
command.
CAPACITY
Code Message
00h Good Status
02h Check
Condition
Chapter 2 SCSI Commands
SET CAPACITY Command
Description
• The drive is ready to perform any
appropriate command.
• The drive remains in any previously
set mode.
• The tape position is at BOT.
• Data on tape is logically inaccessible.
If Immed is 1, then Good Status
Note:
only indicates that the command
is valid.
Use the
REQUEST SENSE
retrieve status information. Possible
Sense Keys are:
Code Message
01h Recovered
Error
02h Not Ready
04h Hardware
Error
05h Illegal
Request
SET
command to
Description
Tape capacity is
rounded up to
20% of total
capacity.
No cartridge is in
the drive.
Drive hardware
failure.
The tape is not at
BOT or the
Command
Descriptor Block
is invalid.
258