Quantum LTO 2 User Manual page 458

Status Name
SCSI_CHIP_PON_COMPLETE_TIME
_OUT
SRV_KLOOP_IS_NOT_CALIBRATED
TAPE_NANOCODE_MISMATCH
MIC_NO_MEDIA_INFO_LTO1
MIC_NO_MEDIA_INFO_LTO2
MIC_BAD_MEDIA_INFO_LTO1
MIC_BAD_MEDIA_INFO_LTO2
SRV_THR_UNTHREAD_STUCK_
ON_GUIDES_EXCEEDED_RETRIES
SRV_UNTHREAD_LAST_DITCH_
FAILED_TO_PUT_PIN_AWAY
SRV_VAR_SPEED_RAMP_UP_
REQUIRES_READ_OR_WRITE_
TRACKING_MODE
SRV_THR_LOAD_ARM_MOVING_
TO_HUB_WHEN_DRIVE_REEL_
SPINNING
SRV_SPEED_TOLERANCE_IS_NOT
_WITHIN_RANGE
LTO-2 SCSI Interface Guide
Sense
Key Category
817h SCSI
818h Servo
819h Tape
81Ah Medium
Auxiliary
Memory
81Bh Medium
Auxiliary
Memory
81Ch Medium
Auxiliary
Memory
81Dh Medium
Auxiliary
Memory
81Eh Servo
81Fh Servo
820h Servo
821h Servo
822h Servo
Appendix A Message Codes
Description
SCSI interface chip power On
Sequence not completed.
The nanocode downloaded does not
match intended nanocode.
Load Arm stuck between corner and
end of guides during Unthread.
Cannot Unthread.
Drive Reel spinning while Load Arm
is going to drive hub.
434