Quantum LTO 2 User Manual page 381

Status Name
SRV_GLOBAL_ERROR_STATE
SRV_REEL_PHYSICAL_EOT_LIMIT
_OVERRUN_IN_HOLD_STATE
SRV_REEL_PHYSICAL_BOT_LIMIT
_UNDERUN_IN_HOLD_STATE
SRV_REEL_LP1_LIMIT_UNDERUN_
IN_HOLD_STATE
SRV_REEL_LP6_LIMIT_OVERRUN_
IN_HOLD_STATE
SRV_SEQ_PAST_EOT_REJ_INV_
STATE_BETWEEN_EOT_AND_
PEOT
SRV_REEL_INVALID_TASK_FOR_
MESSAGE_RESPONSE
SRV_STATEM_SEQUENCER_
STACK_OVERFLOW
SRV_SEQ_STACK_UNDERFLOW
SRV_SEQ_PAST_EOT_REJ_INV_
STATE_EXCEEDING_PEOT
SRV_MOVETAPE_UNEXPECTED_
LPOS_NOTIFICATION_IN_RAMP_
UP_STATE
SRV_MOVETAPE_UNRECOGNIZED_
COMMAND_IN_RAMP_UP_STATE
SRV_STEP_HEAD_COULD_NOT_
FIND_ANY_PES_DURING_HEAD_
CALIBRATION
LTO-2 SCSI Interface Guide
Sense
Key Category
411h Servo
412h Servo
413h Servo
414h Servo
415h Servo
416h Servo
417h Servo
418h Servo
419h Servo
41Ah Servo
41Bh Servo
41Ch Servo
41Dh Servo
Appendix A Message Codes
Description
Firmware global error state
Physical EOT limit overrun occurred
in hold state
Physical BOT limit underrun
occurred in hold state
LP1 limit underrun in hold state
LP6 limit overrun in hold state
LPOS is past EOT based on
ratiometric EOT detection
Sender ID not valid for sending a
message to
Sequencer control stack overflowed.
Sequencer control stack under
flowed.
Tape exceeds EOT per ratio metric
calculation of position
An LPOS notification occurred during
ramp up
Unrecognized command detected at
speed in ramp up state
No PES found during head offset
calibration command.
357