Completion Status; Table 145 Read Block Limits Command Completion Status - Quantum LTO 2 User Manual

Completion Status

Table 145 READ BLOCK LIMITS
Command Completion Status
LTO-2 SCSI Interface Guide
Table 145 shows the completion codes and messages for the
2
command.
LIMITS
Code Message
00h Good Status
02h Check
Condition
Chapter 2 SCSI Commands
READ BLOCK LIMITS Command
Description
• The drive is ready to perform any
appropriate command.
• The drive remains in any previously
set mode.
• The tape position is not changed.
Use the
REQUEST SENSE
retrieve status information. Possible
Sense Keys are:
Code Message
04h Hardware
Error
05h Illegal
Request
06h Unit
Attention
READ BLOCK
command to
Description
Parity error on
the SCSI bus or
drive hardware
failure.
The Command
Descriptor Block
is invalid.
The cartridge
was changed, or
the drive was
reset prior to this
command.
179