Quantum LTO 2 User Manual page 396

Status Name
SRV_CMDPROC_INVALID_DRIVE_
STATE_ON_RAMP_CMD
SRV_CMDPROC_OUT_OF_RANGE_
DRIVE_STATE_ON_RAMP_CMD
SRV_ATTEMPTING_TO_FIND_
PES_RETRY
SRV_SEQ_TARGET_LPOS_NOT_
BEHIND_CURRENT_POSITION
SRV_SEQ_TARGET_LPOS_
EXCEEDED_IN_REPOSITION_COM
MAND
SRV_CART_MEMORY_LP1_AND_
WP_CALC_LP1_NOT_WITHIN_
TOLERANCE
SRV_CM_CALC_CART_TYPE_
DOES_NOT_MATCH_RADIUS_
CALC_CART_TYPE
SRV_CM_LP1_AND_LP6_NOT_
WITHIN_LTO_SPEC
SRV_SEQ_INVALID_LPOS_
DISTANCE_IN_CALCULATE_
OPTIMAL_BACKWARD_SPEED
SRV_LPOS_BOT_UNDERRUN
SRV_MOVETAPE_ERROR_REL_LP1
_UNDERRUN_DURING_RAMP_UP
SRV_MOTOR_REL_LP1_OVERRUN
LTO-2 SCSI Interface Guide
Sense
Key Category
4C2h Servo
4C3h Servo
4C4h Servo
4C5h Servo
4C6h Servo
4C7h Servo
4C8h Servo
4C9h Servo
4CAh Servo
4CBh Servo
4CCh Servo
4CDh Servo
Appendix A Message Codes
Description
Ramp cannot execute at current drive
state
Ramp cannot execute at undefined
drive state
Head stepper module is going to look
for pes after a delay.
Reject command
REPOSITION
Command failed LPOS target past
notification point.
Cartridge memory LP1 value isn't
within tolerance of the Whirlpool
calculated LP
Cartridge type derived from MIC LP1
and LP6 doesn't match cartridge type
calculated
Cartridge memory LP1 and LP6
values don't fall within LTO
specification.
Invalid lpos distance (negative)
calculated in reposition command
Whirlpool relative LP1 (972)
underrun.
Exceeded BOT
Relative LP1 underrun detected by
RTOS
372