Quantum LTO 2 User Manual page 252

Sense
Key ASC
Byte 2 Byte 12
06h Unit Attention
06h 04h
06h 28h
06h 29h
06h 2Ah
06h 2Ah
06h 3Fh
06h 3Fh
06h 3Fh
06h 3Fh
06h 5Dh
06h 5Dh
LTO-2 SCSI Interface Guide
ASCQ
Byte 13 Message
10h Auxiliary Memory
not accessible
00h Not ready to ready
change, medium
may have changed
00h Power on reset or
bus device reset
occurred
01h Mode parameters
changed
02h Log parameters
changed
01h Microcode has been
changed
0Eh Reported LUNs Data
Has Changed
10h Medium Loadable
11h Medium auxiliary
memory accessible.
00h Failure prediction
threshold exceeded
FFh Failure prediction
threshold exceeded
(false)
REQUEST SENSE Command
Explanation
An access attempt was made to the Medium
Auxiliary Memory or the EEPROM that was
not successful.
A tape has been loaded successfully into the
drive and is now ready to be accessed.
The drive has powered on, received a reset
signal or a bus device reset message since the
initiator last accessed the drive.
An initiator other than the one issuing the
command has changed the Mode parameters
for the drive.
An initiator other than the one issuing the
command has changed the Log parameters for
the drive.
Drive firmware has been changed by a
command or firmware tape.
BUFFER
Command Forwarding has been changed
from disabled to enabled or vice-versa.
Medium has transitioned to a loadable state.
Medium has transitioned to MAM accessible
state from a MAM inaccessible state.
TapeAlert flag(s) have been set.
TapeAlert Test flag(s) have been set to test for
Failure Prediction system.
Chapter 2 SCSI Commands
WRITE
228