Quantum LTO 2 User Manual page 31

LTO-2 SCSI Interface Guide
Hex
Message Code
Initiator 05h
Detected
Error
Message 09h
Parity
Error
Message 07h
Reject
No 08h
Operation
Definition
The initiator has detected an error in the data
being sent in a Message Command, Data or
Status phase. The drive will retry the data
burst or message.
If the message is received immediately after
an Identify message or after the Command
Complete message has been sent, the drive
will go Bus Free.
The initiator has detected a parity error in a
message. The drive will retry the message.
If the message is received during a
Command, Data or Status phase,
immediately after an Identify message or
after the Command Complete message has
been sent, the drive will go Bus Free.
This message is sent when the initiator does
not support a message sent by the drive or
considers the message inappropriate. If the
message being rejected is Disconnect,
Synchronous Data Transfer Request or Wide
Data Transfer Request, the operation
continues without those features. For all
other messages except Restore Pointers, the
message is treated as an Abort message.
If the message is received during a
Command, Data or Status phase,
immediately after an Identify message or
after the command complete message has
been sent, the drive will go Bus Free.
This message has no effect and is ignored.
Chapter 1 SCSI Interface
Parallel SCSI Interface
7