Completion Status; Table 199 Reserve Unit Completion Status - Quantum LTO 2 User Manual

Completion Status

Table 199 RESERVE UNIT
Completion Status
LTO-2 SCSI Interface Guide
Table 199 shows the completion codes and messages for the
2
command.
UNIT
Code Message
00h Good Status
02h Check
Condition
Chapter 2 SCSI Commands
RESERVE UNIT Command
Description
• The drive is ready to perform any
appropriate command.
• The drive remains in any previously
set mode.
• The drive is reserved for the use of the
specified ID.
• The tape position is not changed.
Use the
REQUEST SENSE
retrieve status information. Possible
Sense Keys are:
Code Message
02h Not Ready
03h Media Error
04h Hardware
Error
05h Illegal
Request
06h Unit
Attention
RESERVE
command to
Description
No cartridge is in
the drive.
Unrecoverable
data error
encountered.
Parity error on
the SCSI bus or
drive hardware
failure.
The Command
Descriptor Block
is invalid.
The cartridge
was changed, or
the drive was
reset prior to this
command.
246