Quantum LTO 2 User Manual page 375

Status Name
SRV_CMDPROC_REJ_PARM_LPOS_
NOT_WITHIN_LP2_OR_LP6_IN_
GOTO_TO_LPOS_VALID
SRV_CMDPROC_REJ_PARM_NOT_
ENOUGH_TAPE_TO_RAMP_TO_
LPOS_IN_GOTO_LPOS_PARAM_
VALID
SRV_CMDPROC_GOTO_LPOS_
REJECTED_TAPE_NOT_STOPPED
SRV_CMDPROC_GOTO_LPOS_
REJECTED_LP1_LP6_NOT_SET
SRV_MOVETAPE_TIMEOUT_
CALCULATION_ERROR
SRV_CALMEM_SET_TENSION_REJ
_INVALID_STATE
SRV_CALMEM_SET_TAPE_SPEED_
REJ_INVALID_STATE
SRV_INDEX_MOTOR_INTERRUPT_
NOT_DETECTED_AFTER_
ROTATING_DRIVE_MOTOR
SRV_MOVETAPE_RAMPDOWN_
API_FAILED_IN_TIMEOUT_
HANDLER_IN_RAMP_UP_STATE
SRV_OFF_TRACK
SRV_NO_PES_FOUND
SRV_VCM_SHOCK_ERROR
LTO-2 SCSI Interface Guide
Sense
Key Category
3C4h Servo
3C5h Servo
3C6h Servo
3C7h Servo
3C8h Servo
3C9h Servo
3CAh Servo
3CBh Servo
3CCh Servo
3CDh Servo
3CEh Servo
3CFh Servo
Appendix A Message Codes
Description
The LPOS selected for the
GOTO_LPOS command is beyond the
limits.
The distance between the current
position and the target LPOS is to
short...
The tape was not stopped when this
command was received.
The tape parameters were not set
before issuing the GOTO_LPOS
command.
The calculation of a time out time in
the movetape module calculated an
erroneous...
Set tension api call failed during
startup.
Set tape speeds api call failed during
startup.
Motor interrupt not detected after
rotating drive Motor.
An attempt to ramp down the tape
failed after a timeout occurred during
ramp up.
Tracking servo detected off track
event.
No valid PES event.
Tracking servo detected shock
vibration error
351