Quantum LTO 2 User Manual page 323

Status Name
SRV_SELF_ERROR_BUF_OVERFLOW
SRV_SEQ_NON_MECHANICAL_
SCRAMBLER_COMMAND
SRV_SEQ_OUT_OF_RANGE_
SCRAMBLER_COMMAND
SRV_SELF_RTOS_BUF_OVERFLOW
SRV_CMDPROC_UNDEFINED_
TASK_FOR_COMMAND_IN_
BYPASS_MODE
SRV_CMDTYPE_TABLE_
INTEGRITY
SRV_REEL_NO_TASK_SPECIFIED
SRV_STACK_OVERFLOW
SRV_NO_SINECAL_DATA
SRV_BAD_SINECAL_DATA
SRV_NO_SINECAL_INDEX
SRV_NO_LOADRCA_INDEX
SRV_PARAM_TABLE_INTEGRITY
SRV_PARPORT_SCRAMBLER_NOT
_READY_IN_SEND_RESPONSE
SRV_PARPORT_UNDEFINED_
CONDENSED_FORMAT
SRV_CMDPROC_NO_TAPE_TO_
EJECT
LTO-2 SCSI Interface Guide
Sense
Key Category
EFh Servo
F0h Servo
F1h Servo
F2h Servo
F3h Servo
F4h Servo
F5h Servo
F6h Servo
F7h Servo
F8h Servo
F9h Servo
FAh Servo
FBh Servo
FCh Servo
FDh Servo
FEh Servo
Appendix A Message Codes
Description
fiq error buffer to irq buffer overflow.
Non-mechanical command received
by sequencer.
Out of range command received by
sequencer.
fiq rtos buffer to irq buffer overflow.
Undefined task specified.
Table integrity for command type or
parameter table look
Reel task received a message without
a valid sender specified.
Stack overflow.
Sine calibration failed to find 0-xings.
Sine calibration found invalid 0-xings.
Sine calibration couldn't find index.
Sine RCA/RCB load couldn't find
index.
Table lookup not consistent with
COMMAND_ENUM definitions.
Scrambler not ready to accept
command.
Undefined scrambler condensed
format.
Eject attempt rejected because there
was no tape.
299