Quantum LTO 2 User Manual page 454

Status Name
SRV_VAR_SPEED_ENABLE_
REQUIRES_DRIVE_READING_OR_
WRITING
SRV_HEAD_BRUSH_IS_NOT_
PRESENT
SRV_THR_HEAD_BRUSH_SENSOR
_MISSING
SRV_STEPPER_BUSY
SRV_THR_PIVOT_TRACK_
ENGAGE_MISSED_SENSOR
SRV_THR_PIVOT_TRACK_
DISENGAGE_MISSED_SENSOR
SRV_STEP_HEAD_BRUSH_PCC_
UNKNOWN_COMMAND
SRV_STEP_PIVOT_TRACK_PCC_
UNKNOWN_COMMAND
SRV_STEP_HEAD_POSITIONER_
PCC_UNKNOWN_COMMAND
SRV_HEAD_POSITIONER_MISSED_
SENSOR
SRV_THR_HEAD_BRUSH_STUCK_
ON_SENSOR
SCSI_IONA_ER_UNKNOWN_
ASPEN_STATE
IONA_RTOS_UNDEFINED_INSTR
SCSI_IONA_ER_INVALID_
RECEIVED_MESSAGE_COUNT
LTO-2 SCSI Interface Guide
Sense
Key Category
7DFh Servo
7E0h Servo
7E1h Servo
7E2h Servo
7E3h Servo
7E4h Servo
7E5h Servo
7E6h Servo
7E7h Servo
7E8h Servo
7E9h Servo
7EAh SCSI
7EBh General
7ECh SCSI
Appendix A Message Codes
Description
Head Brush sensor not detected.
Stepper Motor is already busy.
Never saw sensor while engaging the
Pivot Track.
Never saw sensor while disengaging
the Pivot Track.
Unknown Head Brush Stepper
command.
Unknown Pivot Track stepper Motor
command.
Low level Head Positioner driver
received an unknown command.
Coarse Head Positioner sensor was
not detected.
Head Brush Cleaner could not get off
of the Head Brush sensor.
Aspen_State variable contains
unknown value.
Iona RTOS undefined instruction
exception interrupt
Aspen_Process_Message got invalid
message count.
430