Quantum LTO 2 User Manual page 334

Status Name
SRV_MOVETAPE_FORWARD_PHY
SICAL_LIMIT_OVERRUN_DURING
_CRUISE_CONTROL
SRV_SEQ_TABLE_LOOKUP_ERROR
SRV_SEQ_MAXIMUM_STATE_
EXCEEDED
SRV_REEL_MAXIMUM_STATE_
EXCEEDED
SRV_CMDPROC_NOT_ENOUGH_
TAPE_TO_RAMP
SRV_SEQ_PAST_LP1_REJ_INV_
STATE
SRV_SEQ_PAST_LP6_REJ_INV_
STATE
SRV_SEQ_REJ_NO_LP1
SRV_CMDPROC_REJ_PARM
SRV_CMDPROC_REJ_INV_DIR
SRV_CMDPROC_REJ_CMD_NOT_
ENOUGH_TAPE_TO_RAMP
SRV_CMDPROC_REJ_CMD_TAPE_
PAST_TARGET_LPOS
SRV_CMDPROC_TAPE_NOT_
STOPPED
SRV_REEL_UNKNOWN_TAPE_
MOVE_COMMAND
LTO-2 SCSI Interface Guide
Sense
Key Category
185h Servo
186h Servo
187h Servo
188h Servo
189h Servo
18Ah Servo
18Bh Servo
18Ch Servo
18Dh Servo
18Eh Servo
18Fh Servo
190h Servo
191h Servo
192h Servo
Appendix A Message Codes
Description
Physical limit exceeded in forward
direction.
Sequencer table incorrectly defined at
compile time.
Sequencer index exceeded maximum
number of functions in table.
Reel task state variable exceeded
number of defined states.
Not enough tape is available to ramp
up before a PBOT or...
Command rejected since we are
already past lp1.
Command rejected since we are
already past lp6.
Command rejected since tape
parameters were not set.
Command rejected in command
processor because...
Command rejected.
Command rejected.
Command rejected.
Command rejected.
Reel task received a command not
recognized.
310