Supported Log Pages; Table 61 Supported Log - Quantum LTO 2 User Manual
Quantum lto 2: user guide
Hide thumbs
Also See for LTO 2:
- User manual (94 pages) ,
- Specifications (1 page) ,
- Quick start manual (4 pages)
Table of Contents
Advertisement
Supported Log Pages
Table 61 Supported Log
Pages
LTO-2 SCSI Interface Guide
The Parameter Control byte specifies:
• Whether or not a counter or a log page is enabled.
• Whether or not a Check Condition is generated when a counter is
incremented, and if so, how the Check Condition is generated.
Each Log Parameter contains only one control byte. This control byte is
shared between the threshold and accumulated parameters. The
data reflects the current setting of the control byte for the
SENSE
parameter.
There are several logs of different formats that allow you to retrieve
2
different drive parameters. The following supported log pages are all
described in detail in the
below:
Log
Supported Log Pages Log Page (00h)
Write Error Counters Log Page (02h)
Read Error Counters Log Page (03h)
Sequential Access Device Log Page (0Ch)
Device Statistics Log Page (14h)
Tape Diagnostic Data Log Page (16h)
Tape Alert Log Page (2Eh)
Tape Usage Log Page (30h)
Tape Capacity Log Page (31h)
Data Compression Log Page (32h)
Error Events Log Page (33h)
chapter, on the pages indicated
LOG SENSE
Chapter 2 SCSI Commands
LOG SELECT Command
LOG
See Page
88
91
92
93
94
96
100
111
112
113
114
78
Advertisement
Table of Contents
