Operation Of Digital Operator; Part Names And Descriptions - Omron RX Series User Manual

3 Operation and Test Run
3-1

Operation of Digital Operator

The Digital Operator is a display operation panel equipped as standard on the 3G3RX-V1 Series
Inverter.
3-1-1

Part Names and Descriptions

The table below shows the name and function of each part of the Digital Operator.
RUN command LED indicator
Operation keys
Part
3 - 4
Data display
Name
POWER LED Lights (green) when the power is supplied to the control circuit.
ALARM LED Lights (red) when the inverter is in a trip error state.
For how to reset a trip error state, refer to How to Reset a Trip State
on page 10-3.
RUN LED Lights (green) during operation.
Program LED Lights (green) when the set value for the selected function is
displayed on the data display.
Blinks if the set value is invalid (during warning).
Refer to 10-2 Warning Function on page 10-12.
Data display Displays the frequency reference value, output current value or set
value, or other relevant data.
Data display LED Lights (green) according to the content of the data display.
Hz: Frequency, V: Voltage, A: Current, kW: Power, %: Rate
RUN command Lights (green) when the RUN command source is set to the Digital
LED indicator Operator.
This indicates that the RUN key of the Digital Operator is enabled.
RUN key Starts inverter operation. Operation via the Digital Operator is
enabled and the RUN command is selected.
Check that the RUN command LED indicator is lit.
STOP/RESET key Stops the inverter.
The STOP/RESET key is enabled by factory setting even when the
RUN command source is not set to the Digital Operator. This key can
be disabled by setting the STOP Key Selection (b087).
When the inverter is in a trip error state, if you press this key, the trip
error state is reset.
High-function General-purpose Inverter 3G3RX-V1 User's Manual (I578-E1)
Function