Hardware Installations and Upgrades
Installing
4x3.5''
1.
Observe the safety and ESD precautions at the beginning of this book.
2.
Power down the server and unplug all peripheral devices and the AC power cable.
Remove the chassis cover. For instructions, see "Removing the Chassis Cover".
3.
Remove the front bezel if it is installed. For instructions, see "Removing the Front Bezel".
4.
5.
Remove the 4x3.5
Hard Drive Cage".
6.
Attach the backplane to the back side of the hot-swap drive cage, and make sure the hooks on the
cage are insterted in the backplane holes (see letter A).
7.
Push the backplane (see letter B) and secure the backplane with the screw (see letter C).
28
Figure 37. Removing 4x3.5'' Hot-swap Backplane
Hot-swap Backplane
''
Hot-swap Hard drives cage. For instructions, see "Removing 4x3.5
Figure 38. Installing 4x3.5" Hot-swap Backplane
®
Intel
Server Chassis P4000S Service Guide
''
Hot-swap