Table of Contents
Advertisement
Hardware Installations and Upgrades
6.
Firmly grab the PCI add-in board by its top edge or outer corners and remove from the expansion slot
on the server board (see letter B).
7.
Install the PCI blank filler and close the PCI add-in card retention device.
Install the chassis cover. For instructions, see "Installing the Chassis Cover".
8.
9.
Plug all peripheral devices and the AC power cable into the server.
10. Power up the server.
Installing PCI Add-in Board(s) for P4304XXSFCN and
P4304XXSHCN
CAUTION
You may want to install an operating system before installing any add-in boards.
Do not overload the server board by installing add-in boards that draw excessive current.
Add-in boards can be extremely sensitive to ESD and always require careful handling. After
removing the board from its protective wrapper, place it component side up on a grounded, static-
free surface. Do not slide the board over any surface.
1.
Observe the safety and ESD precautions at the beginning of this book.
2.
Power down the server and unplug all peripheral devices and the AC power cable.
Remove the chassis cover. For instructions, see "Removing the Chassis Cover".
3.
Install the PCI card guide if full length PCI card is to be installed. For instructions, see "Install PCI
4.
Card Guide" (Only needed when full length PCI card is plugged).
5.
Remove the PCI slot shield (see letter A) by pushing from the shield out from inside the chassis.
48
Figure 68. Removing the PCI add-in card
®
Intel
Server Chassis P4000S Service Guide
Advertisement
Table of Contents
