Installing
4x3.5''
CAUTION
It is critical that you connect the SAS/SATA data cables correctly from the SAS/SATA backplane to
your server board or RAID controller card. Failure to do so may result in data loss.
1.
Observe the safety and ESD precautions at the beginning of this book.
2.
Power down the server and unplug all peripheral devices and the AC power cable.
Remove the chassis cover. For instructions, see "Removing the Chassis Cover".
3.
Remove the front bezel if it is installed. For instructions, see "Removing the Front Bezel".
4.
5.
Install the hot-swap EMI HDD shield under the hot-swap cage.
1)
Fit the edges of the EMI Shiled against the sides of the chassis (see letter A).
2)
While pressing the EMI shiled, slide the EMI Shield downwards until the latches on the EMI
shield are engaged with the chassis (see letter B).
®
Intel
Server Chassis P4000S Service Guide
Figure 33. Removing the EMI shield
Hot-swap Hard Drive Cage with Backplane
Hardware Installations and Upgrades
25