Installing Hot-Swap Hard Drive; Installing 3.5" Hard Disk Drive; Figure 39. Removing The 2.5" Hdd Interface Bracket From Carrier - Intel P4000S Series Service Manual

8. Install the 4x3.5
Drive Cage".
Install the front bezel. For instructions, see "Installing the Front Bezel".
9.
10. Install the chassis cover. For instructions, see "Installing the Chassis Cover".
11. Plug all peripheral devices and the AC power cable into the server.
12. Power up the server.

Installing Hot-swap Hard Drive

Installing 3.5" Hard Disk Drive

CAUTION
The 3.5" hard disk drive can be a SSD or SAS and SATA. Refer to your server board
or system documentation to determine SSD/SAS/SATA support for your server
system.
1. Remove the four screws securing the 2.5" HDD interface bracket and remove the 2.5" HDD interface
bracket.

Figure 39. Removing the 2.5" HDD interface bracket from Carrier

2. Install the 3.5" hard disk drive using the same four screws as shown. Make sure the connector end of the
drive matches the backplane connector.
®
Intel Server Chassis P4000S Service Guide
''
Hot-swap Hard drives cage. For instructions, see "installing 4x3.5
Hardware Installations and Upgrades
''
Hot-swap Hard
29