Removing And Installing The Rear Fixed Fan; Removing The Rear Fixed Fan; Installing The Rear Fixed Fan; Figure 62. Removing The Rear Fixed Fan - Intel P4000S Series Service Manual

Hardware Installations and Upgrades

Removing and Installing the Rear Fixed Fan

NOTE
This procedure applies only to the Intel

Removing the Rear Fixed Fan

1. Observe the safety and ESD precautions at the beginning of this book.
2. Power down the server and unplug all peripheral devices and the AC power cable.
Remove the chassis cover. For instructions, see "Removing the Chassis Cover".
3.
4. Disconnect the appropriate fan power cable from the server board.
5. Locate the four nylon rivets on the four corners of the Fan assembly. From the inside of chassis, push
the push-pins (inner part of the rivit) outward, then remove the sleeves (outer part of the rivit). See
letter A and B.
6. Remove the Fan and the rear vent cover under the Fan (see letter C and D).

Installing the Rear Fixed Fan

1. Observe the safety and ESD precautions at the beginning of this book.
2. Power down the server and unplug all peripheral devices and the AC power cable.
Remove the chassis cover. For instructions, see "Removing the Chassis Cover".
3.
4. Press the rear vent cover and the fan against the inner side of the chassis rear, adjust until the rivet
holes on the chassis, rear vent cover and the fan are aligned with each other (see letter A and B).
5. While holding the rear vent cover and fan, insert the sleeves of the nylon rivet into the rivet holes from
outside of the chassis. Push the push-pins of the nylon rivet into the sleeves (see letter C and D).
42
®
Server chassis P4304XXSFCN and P4304XXSHCN.

Figure 62. Removing the Rear Fixed Fan

®
Intel Server Chassis P4000S Service Guide