Hardware Installations and Upgrades
6.
Install the 4x3.5
1) Slide the 4x3.5
2) Secure the Hard Drive Cage with the Screw (see letter B).
7.
Make the backplane and server board/RAID controller card cable connections. Refer to the
documentation that came with your server board and/or RAID controller card for instructions on
connecting backplane cables to your server board or RAID controller card.
1) Connect data cables (letter A).
2) Connect an I2C_IN cable (letter B).
3) Connect an SGPIO cable (letter C).
4) Connect power cable (letter D).
26
Figure 34. Installing the EMI shield
''
Hot-Swap Hard Drive Cage.
''
Hot-Swap Drive Cage into the slot (see letter A).
Figure 35. Installing the 4x3.5'' Hot-Swap Hard Drive Cage
®
Intel
Server Chassis P4000S Service Guide