Removing And Installing Airduct; Installing The Airduct; Figure 44. Installing The 2.5" Hdd Into Carrier - Intel P4000S Series Service Manual

Hardware Installations and Upgrades

Removing and Installing Airduct

NOTE
Airduct may need to be ordered separately. See Configuration Guide of the server board for which airduct
work with your server board. The installation and/or removing airduct steps in below is generic. Please
see your board or system documents for specific instructions about installing and/or removing airduct.

Installing the Airduct

1. Observe the safety and ESD precautions at the beginning of this book.
2. Power down the server and unplug all peripheral devices and the AC power cable.
Remove the chassis cover. For instructions, see "Removing the Chassis Cover".
3.
4. Install the airduct by aligning the air duct and CPU fans (see letter A) and ensure the tab on air duct is
engaged in its snap-in bracket.(see letter B).
32

Figure 44. Installing the 2.5" HDD into carrier

®
Intel Server Chassis P4000S Service Guide