Hardware Installations and Upgrades
Remove the front bezel if it is installed. For instructions, see "Removing the Front Bezel".
4.
5.
Remove an EMI shield (see picture below).
6.
Get the slides from the chassis side (see letter B). Attach slides to the DVD or CD-ROM drive by
pressing the slides firmly into the side dimples on the DVD or CD-ROM drives (see letter C). Insert
the drive/slide assembly into the device bay until the slides lock into place (see letter D).
7.
Connect the DVD or CD-ROM power cable. See your server board documents for data cable
connection.
Removing and Installing the Fixed HDD EMI Shield
NOTE
For a chassis on its side, position the chassis hanging over the edge of a table or workbench before
removing the bezel.
This procedure applies only to the Intel
Removing the Fixed HDD EMI Shield
1.
Observe the safety and ESD precautions at the beginning of this book.
2.
Power down the server and unplug all peripheral devices and the AC power cable.
18
Figure 20. Removing EMI Shield
Figure 21. Installing DVD or CD-ROM Drive
®
Server chassis P4000S family with fixed HDD configuration.
®
Intel
Server Chassis P4000S Service Guide