Table of Contents
Advertisement
HM 1000/1250
※ Centering the tool pot of the tool magazine
Use the up/down arrow buttons in the [ Jr.0000 ] screen, or press the rotation button on
the manual operation panel. While holding the button, insert the center bar into the
centering fixture until it is inserted smoothly.
▪ When completed, the coordinates of the tool magazine will match with the actual
position.
7) When the centering of the tool magazine's tool
pot is completed, press the SET button.
è [ Jog.run ]
: Return to the jog run mode
8) In the [ Jog.run ] screen, press the MODE
button.
è [ rd-off ]
: Ready to operate the jog run
Back in the [ rd-off ] screen, press the up
arrow button.
è [ Org.S - - ] : Origin mode
HM1000ISE99
81
Advertisement
Table of Contents
