Doosan HM 1000 Installation Manual page 40

HM 1000/1250
1) Move the machine to the coordinates of X1050.
Y1000. Z800.
2) Clean up the table deck and place the level in
the center of the table. Then, perform the
"setting the reference point for the level".
3) Place the completed level in the center of the
table deck in the X and Z directions. Then, feed
the X axis to the coordinates of "X0, X525.,
X1050., X1575., X2100." in five distinct steps.
Adjust the level block bolt to set the leveling
roughly. (set the leveling for both X and Z axes
to 0.04/m)
▪ It is recommended to make coordinate settings for the leveling in advance.
※ Setting example) O 001;
※ Precautions for the leveling work
① Apply force as evenly as possible to each level bolt.
▪ Otherwise, it may cause an improper leveling in the end.
② The last step of the leveling should be ended in the direction that the level bolt is
tightened.
4) When the X axis is leveled roughly, move it to the center (X1050.). Then, place the level
vertically on the grinding side of the column using the magnet and set the level to "0".
38
G90 G00 G54 X0.;
M01;
X525.;
M01;
X1050.;
M01;
X1575.;
M01;
X2100.;
M01;
X1575.;
M01.;
HM1000ISE99
X1050;
M01;
X525.;
M01
M99;