Table of Contents
Advertisement
HM 1000/1250
4) Perform the pallet unclamping manually and use a 30mm wrench to tighten NA24 nut
(for C10051034A shift). Then, use a hexagon wrench to tighten the shift through the cap
hole. If the shift head contacts on the seat plate, loosen the shift by half turn and tighten
it back with the nut.
Seat Plate
5) Install the pallet back into the table in manual
operation.
6) Refer to "3. correcting the table precision"
above to measure the parallelism between
edge locator and X axis. If the measurement is
below the target, finish the assembling.
① Install C68051044 cap and tighten the set-
screw.
② Wrap the removed plugs with a Teflon tape
and insert them back.
68
Nut (NA24)
Shift
Shift
Nut (NA24)
HM1000ISE99
Seat Plate
X axis
Advertisement
Table of Contents
