Table of Contents
Advertisement
HM 1000/1250
2) Y - Z
ⓐ Measure
Install the magnetic square level on the
spindle section in the Z-axis direction and
position it so that you can read the level
gradation. Feed the Z axis in 3-divided
stroke and check the greatest difference of
the level changes.
▪ Measuring point: X0. X1050. X2100.
▪ Tolerance: 0.025mm / full stroke
ⓑ Correction
Incorrectness of the X-axis straightness is
thought to be attributed to an error in the
machine feeding level. So refer to "Machine
Leveling" later in this manual and perform
the leveling again.
3) X - Z
ⓐ Measure
Install the straight edge horizontally on the
pallet in the X-axis direction and install the
indicator on the spindle head. Set either
end of the straight edge to "0" and move the
X axis to check the greatest difference
(measurement in the middle of the
movement).
※ If the straight edge is not available, use
the sides of the square that is required
for measuring the squareness between
X and Y axes.
▪ Measuring point : both ends and center of straight edge
▪ Tolerance: 0.005mm / 300mm
ⓑ Correction
Incorrectness of the X-Z straightness of the X axis is thought to be attributed to an
error in the machine feeding level. So refer to "Machine Leveling" in this manual and
perform the leveling again.
HM1000ISE99
X axis
X axis
49
Advertisement
Table of Contents
