Table of Contents
Advertisement
HM 1000/1250
Ref 1) Adjusting the position of ATC servo magazine
If the ATC sub changer and the tool pot of the magazine do not align properly due to mis-
position of the ATC servo magazine, you must adjust the position of ATC servo magazine
manually.
1) Move the tool pot #1 to the changer position, and install the centering fixture between
tool pot and sub changer.
2) Change the value of "Keep Relay K12.2" to 1.
▪ K12.2(KMATC) : If you adjust the position of
(This will control the servo motor regardless of
the changer arm position)
3) Press the MODE button in the start screen
[r 0000] of the servo drive.
è [ rd-off ]
: Ready to operate the jog run
ATC changer, set it to 1.
HM1000ISE99
79
Advertisement
Table of Contents
