HM 1000/1250
3) Preparing centering fixture
① : Center Bar
② : Fixture for Changer Arm
③ : Fixture for Spindle
4) Remove the spindle driving key and clamp the
spindle fixture into the spindle. Perform the
spindle orientation. (M19)
5) In manual operation, move ATC main changer
to the spindle position.
① In MDI mode, call one of empty pots in the
tool magazine. ( T_ _; )
② Move each axis to the respective tool
changing position. (G91 G30 Y0 Z0)
③ Perform [ ATC Door Open ] ⇒ [ Changer
Spindle Side ] ⇒ [ Changer Right ]
manually in this sequence.
6) Insert the centering fixture into the changer
arm.
① Perform "Pin Unlocking" in manual
operation.
② Insert the changer arm fixture into the
changer arm.
HM1000ISE99
2
1
Fixture for
Spindle
3
77