Extron electronics PowerCage 411 Series User Manual page 48

Command
PowerCage 411 Enclosure Commands Continued
Global unsolicited responses
Slot status
Fan status
Fan status
Power supply status
Power supply status
NOTE:
It will take >10 seconds of a stalled fan to trip a fan fault and blink the power supply LED (green or red).
•
A blinking green LED means the power supply is functioning, but either fan is not functioning.
•
A blinking red LED means the power supply failed, but either fan is not functioning.
• Power supply LEDs table
See the
Status
General information
General information (advanced)
Query firmware version
Query firmware build
Query part number
Query Extron serial number
Query updated FPGA version
X3)
KEY:
= General Information Query
X3!
= Slot status (4 characters)
X3@
= Power supply status (2 characters)
X3%
= Build number
X3^
= Firmware version number
X3&
= Verbose firmware version
ASCII Command Response
(host to PowerCage) (PowerCage to host)
HdwrChange
FAILED:
FAILED:
FAILED:•Power•Supply•1
FAILED:•Power•Supply•2
on page 17
, for more detail on the LEDs.
I/i
Slot
X3)
I
{Specific Information}
Inf
Verbose mode 2/3
Q/q X3^]
Verbose mode 2/3
Ver01*
*Q/q X3%]
Verbose mode 2/3
Bld
N/n
60-1492-02
Verbose mode 2/3
Pno60-1492-02
19I/i
Serial number
Verbose mode 2/3
Inf19*Serial number
35Q/q
x.xx
Verbose mode 2/3
Ver35*
1 = Model Name
3 = System memory Usage [<# Bytes Used out of # Kbytes>]
4 = User Memory Usage [<# Bytes Used out of # Kbytes>]
0 = Not installed,
0 = Failed,
Example: 10 = power supply #1 is on and power supply #2 is failed
x.xx.xxxx
To second decimal place (x.xx)
Description, upload date and time.
PowerCage 411 Series • SIS Configuration and Control
Additional Description
] A board or power supply is added or
removed.
] Internal fan 1 fails. The firmware triggers
• Fan • 1
fan fault whenever it reads
other value means the fan is spinning.
] Internal fan 2 fails.
• Fan • 2
] Internal power supply 1 fails or output
voltage falls below 10% of 12V.
] Internal power supply 2 fails or output
voltage falls below 10% of 12V.
X3!X3!X3! X3! • X3@X3@]
PS
]
X3) •
{Specific Information}
X3^]
View the full firmware version
x.xx.xxxx
X3%]
]
]
]
]
] View the updated loaded FPGA version
]
x.xx
2 = Model Description
1 = Installed, Example: 1111 = all 4 slots are installed
1 = On, 2 = Not installed
0
RPM. Any
Show slot status and
power supply status.
]
40