Extron electronics PowerCage 411 Series User Manual page 44

X1@ = RS-232 Parity
X1# = RS-232 Data Bits
X1$ = RS-232 Stop Bits
X1% = Password
NOTE: The factory configured passwords for all accounts on this device have been set to
the device serial number. In the event of a complete system reset, the passwords convert
to the default, which is extron.
X2! = Timeout
X2@ = Voltage
X2$ = Fan speed
X2% = Power Supply LED #1
X2^ = Power Supply LED #2
X2& = Verbose/response mode
X2* = UARTs
X2( = Internal temperature
X3) = General Information Query
X3! = Slot Status (4 characters)
X3@ = Power Supply Status
X3# = Enable Telnet port
X3$ = Port number
X3% = Build number
X3^ = Firmware version number
X3& = Verbose firmware version-description-upload date and time.
X4@ = Video mute
X4# = Audio output
X4$ = Input video signal status
X4% = Display input audio status
X4^ = Input HDCP status
Odd Even None (default)
7, 8 (default)
1 (default), 2
Maximum length 128 characters. All alpha-numeric characters
permitted except |, and "single space".
The number of seconds (each step = 10 seconds) before
timeout on IP connections (min = 1, max = 65000
[default = 30 = 300 seconds]).
Positive or negative voltage and magnitude
Revolutions per minute (RPM)
0 = Failed (Red) 1 = On (Green)
3 = Not Connected
0 = Failed (Red) 1 = On (Green)
3 = Not Connected
0 = Clear/none (default for the LAN port),
1 = Verbose mode (default for the RS-232 port),
2 = Tagged response for queries
3 = Verbose mode and tagged responses for queries
0 = Frame 1 = Slot 1 (UART 1)
3 = Slot 3 (UART 3) 4 = Slot 3 (UART 4)
Degrees Fahrenheit and Celsius (xxx.xF•xx.xC)
1 = Model Name 2 = Model Description
3 = System memory Usage [ <# Bytes Used out of # Kbytes>]
4 = User Memory Usage [ <# Bytes Used out of # Kbytes>]
0 = Not Installed 1 = Installed
(example: 1111 = All 4 slots are On)
0 = Failed 1 = On 2 = Not Installed (2 characters)
0 = Off (default) 23 = Telnet Port 23 enabled
5 digits with leading zeros (example 00000 or 00023)
x.xx.xxxx
To second decimal place (x.xx)
0 = Unmute (default) 1 = Mute video only
3 = Mute video and sync
1 = Digital (Tx Loop Out or Rx HDMI Out),
2 = Analog (Tx Return Out or Rx Analog Output),
3 = All outputs (digital and return/analog)
0 = Not detected, 1 = Detected
0 = Not detected, 1 = Detected
0 = No source detected
1 = Source with HDCP detected (default)
2 = Source with no HDCP present
PowerCage 411 Series • SIS Configuration and Control
Mark Space
2 = No AC (Orange)
2 = No AC (Orange)
2 = Slot 2 (UART 2)
36