Table of Contents
Advertisement
Resetting the PowerCage 411 Enclosure with the Reset Button
NOTE: The front panel Reset button only resets the enclosure and not the boards
There are three reset modes (numbered 1, 4, and 5) that can be accessed by pressing the
Reset button on the front panel. Use a pointed stylus, ballpoint pen, or Extron Tweeker to
press the recessed Reset button (see the
on page 21).
CAUTION: Review the reset modes carefully. Using the wrong reset mode may result
ATTENTION : Étudier de près les différents modes de réinitialisation. Appliquer
NOTE: The reset modes listed in the table close all open IP and Telnet connections
Figure 14.
NOTES:
installed in the slots.
in unintended loss of flash memory programming, port reassignment, or processor
reboot.
le mauvais mode de réinitialisation peut causer une perte inattendue de la
programmation de la mémoire flash, une reconfiguration des ports ou une
réinitialisation du contrôleur.
and close all sockets. Also, each mode is a separate function, not a continuation from
mode 1 to mode 5.
Mode 1
RESET
Press and hold
the Reset button.
Mode 4
RESET
Press and hold
for 6 seconds.
Mode 5
RESET
Press and hold
for 9 seconds.
Resetting the PowerCage 411
•
After a mode 1 reset is performed, update the firmware for the PowerCage 411 to
the latest version. Do not operate the firmware version that results from the mode 1
reset. If the factory default firmware is to be used, that version must be uploaded
again.
•
If you do not want to update firmware, or a mode 1 reset was performed by
mistake, cycle power to the device to return to the firmware version that was
running before the mode 1 reset. Use the 0Q SIS command (see
version
on page 40) to confirm that the factory default firmware is no longer
running (look for the asterisk [*] following the version number).
PowerCage 411 Reset Mode Summary
Release Reset button.
RESET
Apply power
to the PowerCage.
Release, then immediately
press and release again.
Reset LED flashes twice.
Reset LED flashes, then goes off.
RESET
RESET
Release, then immediately
press and release again.
Reset LED flashes three
Reset LED flashes, then goes off.
times.
RESET
RESET
PowerCage 411 Series • Operation
table
Query firmware
20
Advertisement
Table of Contents
