Extron electronics PowerCage 411 Series User Manual page 51

Command
FOX3 PC Transmitter Commands Continued
Information requests
View input video status
View input audio status
View input HDCP status
View output HDCP status
X4$
KEY: = Input video signal status
X4%
= Display input audio status
X4^
= Display input HDCP status
X4&
= Output HDCP status
Resets
Erase all files from flash memory
Reset unit settings
Absolute system reset (retain IP)
Absolute system reset
IP system reset
Reset audio gain and attenuation
Global unsolicited responses
Input change
Fiber link
Input video signal presence
Input HDCP
Output HDCP
Audio input status
X4$
KEY: = Input video signal status
X4%
= Display input audio status
X4^
= Input HDCP status
X4&
= Output HDCP status
X5#
= Active fiber link
X5$
= Fiber Link detection (SPF A/B IN LED) 0 = Not detected
SFP A and SFP B OUT LED is always active.
NOTE:
ASCII Command Response
(host to PowerCage) (PowerCage to host)
4S/s X4$
Verbose mode 2/3
Sts04*
5S/s X4%
Verbose mode 2/3
Sts05*
E X4^
}
IHDCP
Verbose mode 2/3
HdcpI
E X4&
}
OHDCP
Verbose mode 2/3
HdcpO
0 = Not detected
0 = Not detected
0 = No source detected
2 = Source with no HDCP present
0 = No active sink detected
2 = Sink detected, output not encrypted
E
} Zpf
ZFFF
E
} Zpx
ZXXX
E Zpy
}
ZY
E Zpq
}
ZQQQ
E Zpq1
}
1ZQQQ
E
} Zpa
ZA
Reconfig
Sts02*
SigI
HdcpI
HdcpO
Sts05*
0 = Not detected
0 = Not detected
0 = No source detected
2 = Source with no HDCP present
0 = No active sink detected
2 = Sink detected, output not encrypted
1 = SFP A
PowerCage 411 Series • SIS Configuration and Control
Additional Description
]
X4$
]
]
X4%
]
]
X4^
]
]
X4&
]
1 = Detected
1 = Detected
1 = Source with HDCP detected (default)
1 = Sink detected, output encrypted
]
Removes files created in user space.
]
Resets unit to factory default.
]
Same as
settings.
]
Master Reset, resets IP address and
subnet mask to default. Also resets all
installed cards.
]
Resets only IP settings.
]
Reset audio gain & attenuation to default
levels.
]
Any change of the input frequency, during
module install, or a power cycle.
X5# X5$ Any change in fiber link status.
]
*
X4$ Any change in input signal status.
]
X4^ Any change in input HDCP status.
]
X4& Any change in output HDCP status.
]
X4% Displays input audio selection status.
]
1 = Detected
1 = Detected
1 = Source with HDCP detected
1 = Sink detected, output encrypted
2 = SFP B
1 = Detected
E
ZQQQ except excludes IP
43