Extron electronics PowerCage 411 Series User Manual page 20

NOTES:
• Ensure the proper fiber cables for the transmitter and receiver pair are used.
Typically, singlemode fiber has a yellow jacket and multimode cable has an
orange or aqua jacket.
• See figure 6 for fiber cable connections. Connect the transmitter to a receiver
in one of three ways:
One way (transmitter to receiver) only, connect transmitter Outputs A (
•
receiver Inputs A (
• Two way (transmitter to receiver and return), connect transmitter Outputs
A ( ) to receiver Inputs A (
1
receiver Inputs A (
• Output B is available to transmit a 4K @ 60 Hz uncompressed signal when
the FOX3 4K @ 60 Hz Uncompressed Video LinkLicense is purchased.
Port A Out (required) — For all one-way video, audio,
1
and serial communications from the transmitter to the
receiver, connect a fiber optic cable to the Out LC port.
Connect the opposite end of this fiber optic cable to
the Port A In LC port on a receiver or to any other
compatible Extron FOX3 device.
Port A In (optional) — For one-way return audio,
2
USB, and serial communications from the receiver to
the transmitter, connect a fiber optic cable to the In LC
port.
Connect the opposite end of this fiber optic cable to
the Port A Out LC port on a receiver or to any other
compatible Extron FOX3 device.
).
1
) and connect transmitter Outputs A (
1
).
2
PowerCage 411 Series • Installation
) to
1
) to
2
A B
OUT IN OUT IN
Transmitter
1 1 2 2
2 2 1 1
Receiver
INPUTS
A B
OUT IN OUT IN
Figure 6. Connection
12