Transmitter Rear Panels - Extron electronics PowerCage 411 Series User Manual

Transmitter Rear Panels

E E E F F F G G G
A B
OUT IN OUT IN N
OUT UT UT UT T I
USB HID USB 2.0
AUDIO IN
RS-232
Tx Rx G HDMI INPUT LOOP OUT
A A A B B B C C C B B B D D D C C C
Figure 5.
Analog audio input
A
RS-232 port
B
HDMI input
C
HDMI Loop Out
D
Analog audio input — Connect an analog audio source to the 3.5 mm tip-ring-sleeve
A
(TRS) port (see
RS-232 port — Connect a control device or controlled device to this 3-pole captive
B
screw port for pass-through RS-232 serial control (see
page 15).
HDMI input — Connect video sources to the HDMI inputs.
C
HDMI Loop Out — If desired, connect a local monitor to this HDMI output.
D
NOTE: Use Extron HDMI LockIt Cable Lacing Brackets to secure HDMI cables to
USB HID Host port (FOX3 T 301/311 PC only) — Connect a USB type A to B cable
E
between this USB type B port and the USB port of a host. The USB HID port is used
only for a mouse or keyboard.
USB 2.0 port (FOX3 T 301 PC only) — Connect a USB type A to B cable between
F
this USB type B port and the USB port of a host. The USB 2.0 port is used for thumb
drives, cameras, keyboards, a mouse, CAC reader, and such devices.
Fiber connector and LED indicators — Connect a fiber optic cable between fiber
G
ports on compatible devices. Each fiber port is split into a Tx (OUT) port and an Rx (IN)
port (see wiring instructions and
AVERTISSEMENT : Risque potentiel de blessure grave ou de mort. Le
E E E E E
OUT IN OUT IN
OUT
USB HID
AUDIO IN
RS-232
Tx Rx G HDMI INPUT
B B B
A A A C C C
FOX3 PC Transmitter Panels
Analog Audio Connection
the device (see HDMI Connection
WARNING: Potential risk of severe injury. The units output continuous
invisible light (Class 1 rated), which may be harmful to the eyes; use with caution.
Plug the attached dust cap into the optical transceiver when the fiber optic cable
is unplugged.
produit émet une lumière invisible en continu (conforme à la classe 1) qui peut
être dangereux pour les yeux, à utiliser avec précaution. Branchez la protection
contre la poussière dans l'ensemble émetteur/récepteur lorsque le câble fibre
optique est débranché.
G G G
A B
N
UT UT UT T I
AUDIO IN
LOOP OUT
A A A
D D D
USB HID port (FOX3 T 301/311 PC only)
E
USB 2.0 port (FOX3 T 301 PC only)
F
SFP modules
G
on page 14 for wiring instructions).
RS-232 Connection
on page 14).
figure 6 on page 12).
PowerCage 411 Series • Installation
G G G
A B
OUT IN OUT IN N
OUT UT UT UT T I
RS-232
Tx Rx G HDMI INPUT LOOP OUT
D D D
B B B C C C
on
11