Table of Contents
Advertisement
Connection Details
HDMI Connection
To secure the HDMI cable to the HDMI ports, use an Extron LockIt Cable Lacing Bracket
and a tie wrap.
1
Figure 8.
1.
2.
3.
Audio Plugs.eps
Tip (+)
4.
5.
Sleeve ( )
RCA Connector
Analog Audio Connection
The analog audio connector and Auto Audio Input Format table are shown in figure 9.
Tip (+)
Ring (-)
Sleeve ( )
3.5 mm Stereo Plug Connector
(balanced)
Figure 9.
Tip (L)
The table in figure 9 shows the audio format sent over the fiber connection when a specific
Ring (R)
audio format is not specified (see
audio source).
Sleeve ( )
3.5 mm Stereo Plug Connector
(unbalanced)
3
2
LockIt Cable Lacing Bracket Installation
Plug the HDMI cable into the panel connector (see figure 8,
Loosen the HDMI connector mounting screw from the panel (
LockIt to be placed over it. The screw does not have to be removed.
Place the LockIt on the screw and against the HDMI connector (
the screw to secure the bracket.
ATTENTION:
•
Do not overtighten the HDMI connector mounting screw. The shield to which it
fastens is very thin and can easily be stripped.
•
Ne serrez pas trop la vis de montage du connecteur HDMI. Le blindage auquel
elle est attachée est très fin et peut facilement être dénudé.
Loosely place the included tie wrap around the HDMI connector and the LockIt (
While holding the connector securely against the cable lacing bracket, use pliers or a
similar tool to tighten the tie wrap, then remove any excess length (
HDMI Embedded
Analog Audio Connector and Auto Audio Input Format Table
4
3
5
Auto Audio Input Format
Analog Audio
Audio Present
Present
Yes
No
Yes
Yes
No
Yes
No
No
Input audio selection
PowerCage 411 Series • Installation
).
1
) enough to allow the
2
), and then tighten
3
4
).
5
Audio Sent Over Fiber
HDMI embedded audio
HDMI embedded audio
Analog audio
No audio
on page 42 to switch the active
).
14
Advertisement
Table of Contents
