Table of Contents
Advertisement
RS-232 Connection
Wire the remote RS-232 connector as shown in figure 10. The default baud rate is 9600.
NOTE: To set RS-232 protocol for the frame and the individual cards, use the serial port
parameter SIS commands for the enclosure (see
RS-232 Insertion for the individual cards can be configured via PCS (See General
Settings in the PowerCage 411 Series Help File).
RS-232
Tx Rx G
Figure 10.
Each transmitter is set to captive screw pass through. Captive screw pass through passes
serial data over the fiber and RS-232 connection on a transmitter or receiver.
Do not tin the wires!
Bidirectional
Ground (G)
Receive (Rx)
Transmit (Tx)
RS-232 Wiring
RS-232 port
on page 44).
Controlling
Device
Ground (G)
Receive (Rx)
Transmit (Tx)
PowerCage 411 Series • Installation
15
Advertisement
Table of Contents
