Aiming Pointer; Aiming Duration Timer - Datalogic PowerScan 9500 Series Product Reference Manual

Enter/Exit Programming Mode

Aiming Pointer

Enables/disables the aiming pointer for all symbologies.
$CTAAP01(CR)
Aiming Pointer = Enable

Aiming Duration Timer

Specifies the frame of time the aiming pointer remains on after decoding a
label, when in trigger single mode.The range for this setting is from 1 to
255 seconds in 1-second increments. See
description of this feature.
DEFAULT
LSTM
Set Aiming Duration Timer
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
76
$CTAAP00(CR)
Aiming Pointer = Disable
DEFAULT
page 298
LSTM00
Aiming Off After Decoding
To configure, scan the ENTER/EXIT PROGRAMMING
MODE bar code above, then the bar code at left fol-
lowed by the digits from the Alphanumeric charac-
ters in
Appendix D, Keypad
desired character(s). End by scanning the ENTER/
EXIT bar code.
~
CANCEL
PowerScan™ PD9530/PBT9500/PM9500
in "References" for a
representing your