Good Read Led Duration - Datalogic QuickScan 2500 Series Product Reference Manual

LED AND BEEPER INDICATORS

Good Read LED Duration

This feature specifies the amount of time that the Good Read LED remains on following
a good read. The good read LED on time can be set within a range of 100 milliseconds to
25,500 milliseconds (0.1 to 25.5 seconds) in 100ms increments. A setting of 00 keeps
the LED on until the next trigger pull.
See
page 285
ture.
$CLAGL00
Select Good Read LED Duration Setting
$CLAGL
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
1. Available only for QuickScan
1
in "References" for detailed instructions and examples for setting this fea-

003 = Good Read LED stays on for 300 msec.
™
QD2500.
ENTER/EXIT PROGRAMMING MODE
Good Read LED Duration Setting =
Keep LED on until next trigger pull
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in Appendix D, Keypad
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.
CANCEL
PRODUCT REFERENCE GUIDE
represent-
101